Si-71A For R(Y)71K
Removal Procedure 185
3) Remove the ambient air
thermistor.
2 Disconnect the motor
operated valve coil, and
crank case heater
connectors from the PC
board.
Note :
If not dismounting the rear/side casing,
remove the 2 screws of the electrical
parts box.
3 Remove the electrical parts
box installation screw.
4 Remove the electrical parts
box by pulling it toward
yourself and lifting.
Caution
Be careful of the lead wire protruding
from the rear surface of the electrical
parts box.
Step Procedure Points
To Next Page
