To set the clock
1. Press “CLOCK button”.
is displayed.
blinks.
2. Press “TIMER setting button” to set the clock to the
present time.
Holding down “ ” or “ ” button rapidly increases or
decreases the time display.
3. Press “CLOCK button”.
blinks.
Turn the breaker ON
• Turning ON the breaker opens the flap, then closes it again.
(This is a normal procedure.)
NOTE
Tips for saving energy
•
Be careful not to cool (heat) the room too much.
Keeping the temperature setting at a moderate level helps save energy.
•
Cover windows with a blind or a curtain.
Blocking sunlight and air from outdoors increases the cooling
(heating) effect.
•
Clogged air filters cause inefficient operation and waste energy. Clean them once every two weeks.
Please note
•
The air conditioner always consumes 15-35 watts of electricity even while it is not operating.
•
If you are not going to use the air conditioner for a long period, for example in spring or autumn, turn
the breaker OFF.
•
Use the air conditioner in the following conditions.
•
Operation outside this humidity or temperature range may cause a safety device to disable the system.
1, 3
2
Recommended temperature setting
For cooling: 78˚F – 82˚F
For heating: 68˚F – 75˚F
Mode Operating conditions If operation is continued out of this range
COOL Outdoor temperature: 14 to 115˚F
Indoor temperature: 64 to 90˚F
Indoor humidity: 80% max.
•
A safety device may work to stop the operation.
•
Condensation may occur on the indoor unit and drip.
HEAT Outdoor temperature: 5 to 64˚F
Indoor temperature: 50 to 86˚F
•
A safety device may work to stop the operation.
DRY Outdoor temperature: 14 to 115˚F
Indoor temperature: 64 to 90˚F
Indoor humidity: 80% max.
•
A safety device may work to stop the operation.
•
Condensation may occur on the indoor unit and drip.
To Next Page
Loading...
Need help?
General
