EDUS121131 CDXS, FDXS Series
Operation Manual 419
3
4.9 ON TIMER Operation
18
ON TIMER Operation
To use ON TIMER operation
Check that the clock is correct.•
If not, set the clock to the present time.
Page 10
Press
1.
.
“ ” is displayed on the LCD.
“
” blinks.
“ • ” is no longer displayed on the LCD.
Press
2.
until the time setting reaches the
point you like.
Each pressing of either button increases or decreases the time setting by 10 minutes. •
Holding down either button changes the setting rapidly.
Press
3.
again.
“ • ” and setting time are displayed on the LCD.
The TIMER lamp lights yellow.•
Display
To cancel ON TIMER operation
Press .
“ • ” and setting time are no longer displayed on the LCD.
“ •
” and day of the week are displayed on the LCD.
The TIMER lamp goes off.•
To combine ON TIMER and OFF TIMER
A sample setting for combining the 2 timers is shown below.•
(Example)
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
ON TIMER at 14:00
Combined
NOTE
In the following cases, set the timer again.
After a breaker has turned off.•
After a power failure.•
After replacing batteries in the remote controller.•
To Next Page
Loading...
Need help?
General
