Daikin VRV III - Page 125

Accessories ED34-862
120 FXFQ-P
JC : 3P179341C
Slit
769mm
A=245mm
A=287mm
160
80
A
80 A=245mm
A=287mm
160
A
80
160
A=245mm
A=287mm
Slit
80
160
A=245mm
A=287mm
A
778mm 765mm 772mm
A
KDTP55K160
KDTP55K80
FCQ(N)71KVEA
FCQ(N)100·125·140KVEA
FXFQ25~80PVE
FXFQ100·125PVE
SkyAir
SkyAir
VRV
VRV
11111
· This manual
Precautions
Combination table
Parts content
This kit can be mounted to an ceiling mounted cassette-type air conditioner <round flow>.
According to the chart below, check the model name of indoor unit, then mount the kit.
This kit cannot be used for the mounting of humidifier and branch duct.
Model name
Name
Shape
Number of pieces
Name
Shape
Number of pieces
Installable indoor unit model name
1 Side insulator plate (1)
6 Top insulator plate (2) 7 Top insulator plate (3) 9 Panel insulator Others8 suspension bracket insulator
2 Side insulator plate (2) 3 Side insulator plate (3) 4 Side insulator plate (4) 5 Top insulator plate (1)
1144
8
2
2
1
7
3
5
6
Slit
Slit
Perform the work on soft cloth to prevent damage to the indoor unit and panel.
4
1
4
9
3
Side insulator plate (3)
Side insulator plate (2)
Sticking Procedure
<Procedure>
(1) According to the sticking procedure for the side insulator plate, stick the side insulator plates (1 to 4) in sequential
order without leaving any gap in between. (Figure 1)
(When mounting the fresh air intake kit (KDDP55X160), cut off the side insulator plate (2) with a cutter knife along the
perforation. The cut-off insulator is no longer needed.)
(2) Stick the top insulator plates (1 to 3) without leaving any gap in between. Also, stick the top insulator plates without
leaving any gap against the side insulator plates all the way around. (Figure 2)
(3) Hang the product.
(4) Stick the suspension bracket insulator to the suspension bracket together with the washer and bolt. (Figure 3)
(5) Lastly, stick the panel insulator to the backside of the panel. (Figure 4)
Top insulator plate (2)
Top insulator plate (3)
Top insulator plate (1)
(Figure 2)
(Figure 3)
(Figure 4)
* Fresh air intake kit
When mounting (KDDP55X160), cut off
the insulator along the perforation.
Perforation
Suspension bracket
(4 points)
Suspension bracket
(4 points)
Side insulator plate (1)
Slit
Side insulator plate (4)
Sticking reference for
side insulator plate (2)
Sticking reference for
side insulator plate (3)
Sticking reference for
side insulator plate (4)
Sticking reference for
side insulator plate (1)
At the suspension bracket section,
the slit must be passed through.
At the suspension bracket section,
the slit must be passed through.
Sticking procedure for side insulator plate
(Figure 1)
Suspension bracket insulator
* After hanging the product, stick the
suspension bracket insulator.
Panel insulator
Panel insulator
Match these corners
before sticking.
Все каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html