Specifications ED34-862
246 FXMQ-P
Ceiling Mounted Duct Type
Note:
∗1 Indoor temp. : 27°CDB, 19.5°CWB / outdoor temp. : 35°CDB / Equivalent piping length : 7.5 m, level difference : 0 m.
∗2 Indoor temp. : 27°CDB, 19.0°CWB / outdoor temp. : 35°CDB / Equivalent piping length : 7.5 m, level difference : 0 m.
∗3 External static pressure is changeable in 13 or 14 stages within the ( ) range by remote controller.
∗4 Air filter is not standard accessory, but please mount it in the duct system of the suction side. Select its colorimetric method (gravity method)
50% or more.
5 Capacities are net, including a deduction for cooling (an addition for heating) for indoor fan motor heat.
∗6 Anechoic chamber conversion value, measured at a point 1.5 m downward from the unit centre. During actual operation, these values are
normally somewhat higher as a result of ambient conditions.
7 Refer to page 255 for Fan Motor Input.
Model FXMQ40PVE FXMQ50PVE FXMQ63PVE FXMQ80PVE
∗1 Cooling Capacity (19.5°CWB)
kcal/h 4,000 5,000 6,300 8,000
Btu/h 16,000 19,800 24,900 31,700
kW 4.7 5.8 7.3 9.3
∗2 Cooling Capacity (19.0°CWB) kW 4.5 5.6 7.1 9.0
Casing Galvanized Steel Plate Galvanized Steel Plate Galvanized Steel Plate Galvanized Steel Plate
Dimensions: (H×W×D) mm 300×700×700 300×1,000×700 300×1,000×700 300×1,000×700
Coil (Cross
Fin Coil)
Rows×Stages×Fin Pitch mm 3×16×1.75 3×16×1.75 3×16×1.75 3×16×1.75
Face Area m² 0.148 0.249 0.249 0.249
Fan
Model — — — —
Type Sirocco Fan Sirocco Fan Sirocco Fan Sirocco Fan
Motor Output × Number
of Units
W 140×1 350×1 350×1 350×1
Air Flow Rate (HH/H/L)
m³/min 16/13/11 18/16.5/15 19.5/17.5/16 25/22.5/20
cfm 565/459/388 635/582/530 688/618/565 883/794/706
External Static
Pressure
Pa Standard 100 (160-30
∗3) Standard 100 (200-50 ∗3) Standard 100 (200-50 ∗3) Standard 100 (200-50 ∗3)
Drive Direct Drive Direct Drive Direct Drive Direct Drive
Temperature Control
Microprocessor Thermostat
for Cooling and Heating
Microprocessor Thermostat
for Cooling and Heating
Microprocessor Thermostat
for Cooling and Heating
Microprocessor Thermostat
for Cooling and Heating
Air Filter
∗4 ∗4 ∗4 ∗4
Piping
Connections
Liquid Pipes mm φ6.4 (Flare Connection) φ6.4 (Flare Connection) φ9.5 (Flare Connection) φ9.5 (Flare Connection)
Gas Pipes mm
φ12.7 (Flare Connection) φ12.7 (Flare Connection) φ15.9 (Flare Connection) φ15.9 (Flare Connection)
Drain Pipe mm
VP25
External Dia. 32
Internal Dia. 25
VP25
External Dia. 32
Internal Dia. 25
VP25
External Dia. 32
Internal Dia. 25
VP25
External Dia. 32
Internal Dia. 25
Mass (Weight) kg 28 36 36 36
∗6 Sound Level (HH/H/L) dBA
220V 39/37/35 41/39/37 42/40/38 43/41/39
240V 39/37/35 41/39/37 42/40/38 43/41/39
Safety Devices
Fuse.
Fan Driver Overload
Protector.
Fuse.
Fan Driver Overload
Protector.
Fuse.
Fan Driver Overload
Protector.
Fuse.
Fan Driver Overload
Protector.
Refrigerant Control Electronic Expansion Valve Electronic Expansion Valve Electronic Expansion Valve Electronic Expansion Valve
Connectable Outdoor Unit R-410A PA Series R-410A PA Series R-410A PA Series R-410A PA Series
Standard Accessories
Operation Manual.
Installation Manual. Drain
Hose. Clamp Metal.
Insulation for Fitting. Sealing
Pads. Clamps. Washers.
Screws. Air Discharge
Flange. Air Suction Flange.
Operation Manual.
Installation Manual. Drain
Hose. Clamp Metal.
Insulation for Fitting. Sealing
Pads. Clamps. Washers.
Screws. Air Discharge
Flange. Air Suction Flange.
Operation Manual.
Installation Manual. Drain
Hose. Clamp Metal.
Insulation for Fitting. Sealing
Pads. Clamps. Washers.
Screws. Air Discharge
Flange. Air Suction Flange.
Operation Manual.
Installation Manual. Drain
Hose. Clamp Metal.
Insulation for Fitting. Sealing
Pads. Clamps. Washers.
Screws. Air Discharge
Flange. Air Suction Flange.
Drawing No. C : 3D060388A
( )( )( )( )
Conversion Formulae
kcal/h=kW×860
Btu/h=kW×3412
cfm=m³/min×35.3
Все каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html
To Next Page
Loading...
