ED34-862 Accessories
FXFQ-P 87
2
3. INSTALLATION OF THE DECORATION PANEL TO THE INDOOR UNIT BODY
<<Refer to the installation manual attached to the indoor unit for the installation of the indoor unit.>>
(1) Match the “PIPING SIDE” and “DRAIN SIDE” displays on the decoration panel with the position of the pip-
ing section and drain section on the indoor unit.
(2) Install the decoration panel
1 Temporarily install the decoration panel to the indoor unit by hanging the temporary latch of the deco-
ration panel to the hook of the indoor unit body. (2 locations)
2 Hook the four mounting brackets on the corner sections of the decoration panels onto the hooks around
the main indoor unit body.
(Make sure at this time that the swing motor lead wire does not get caught between the decoration panel
and the main unit.)
3
Screw all 4 hexagon head screws located right beneath the latches in approximately 5 mm. (Panel will rise)
4 Adjust the decoration panel by turning it to the arrowed direction in Fig. 6 so that the ceiling opening is
completely covered.
Hook
Hook
(4 locations)
(2 locations)
Drain
section
Piping section
Mounting bracket
Temporary latch
“PIPING SIDE” marking
“DRAIN SIDE” marking
Fig. 6
1
3 5
4
2
5
Tighten the screws until the thickness of the sealing material between the decoration panel and the
indoor unit body reduces to 5-8 mm.
Sealing material
Decoration panel
5 - 8mm
Indoor unit
Swing flaps
Ceiling
material
Все каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html
To Next Page
Loading...
