60 Form # SF-99007 • Part #: 041541502-D
Warranty Registration Form (Scroll)
Warranty Registrat ion Form (Scro ll)
Attention: W arranty Department Scroll Compressor Equipment Warranty Registration Form
Daikin
This f orm must be completely filled out and returned to the
P.O Box 2510
Staunton Warranty Department w ithin
ten (10) days
of start-up in order to comply
Staunton, VA 24402-2510
w ith the terms of "Daikin Limited Product Warranty".
Note: Use OM and IMM or Later Manuals
Job Nam e: Startup Date:
Daikin G.O. No.: Daikin S.O. No.:
Installation Address: City/State/Zip:
Purchasing Contractor:
Phone :
City/State /Zip: No. of units at s ite :
Unit M odel No.: Serial No.:
Com pressor # 1 Serial #:
Com pressor # 4 Serial No.:
Com pressor # 2 Serial. #:
Com pressor # 5 Serial No.:
Com pressor # 3 Serial #:
Com pressor # 6 Serial No.:
Benshaw/DRC Control Box M/M #: Benshaw/DRC Control Box S/N #:
I. PRE START-UP PROCEDURE
II. Pre Start-Up Checklist
Pre Start-Up Checklist, All NO checks require an explanation under "Description". Please check yes or no.
YES NO
A. Is the unit free of visible shipping damage, corrosion or paint problems?
B. Is unit installed level?
C. Does the unit meet all location, installation and service clearances per IM Bulletin?
D. Has thermostat bulb been properly installed in the well?
E. Are all set screws on all pulleys, bearings, and fans tight?
F. Does electrical service correspond to unit nameplate?
Volts Hertz Phase
G. Has electrical service been checked for proper phasing at each circuit power terminal block?
H. Has unit been properly grounded?
I. Has a fused disconnect and fuses or breaker been sized per product manual and installed per local code?
J. Are all electrical power connections tight?
K. Have compressor heaters and oil separator heaters been
been operating for 24 hours prior to start-up?
L. Does all field wiring conform to unit electrical specifications?
Che ck, Te st a n d Com m i ssi on i n g for
Scroll Product (AGZ, ACZ, WGZ, TGZ)
To Next Page
Loading...
