Adeo Group s.r.l.
Via della Zarga n. 50 - 38015 LAVIS (TN)
Tel: +39 0461 248211 - Fax: +39 0461 245038
Mail: info@adeogroup.it – www.adeogroup.it
Adeo Control SGDD-C4-4
Manual
Ad e o C o n t r o l i s a b r a n d o f A d e o G ro up s . r .l .
Only in Dali config mode (page 11) is it possible to change the parameters to be sent to the
BUS DALI, which are:
Transmit as
“address” Send address commands
”group” Send group commands
“broadcast” Send broadcast commands
Send command “OFF” instead of”DAPC 0”
Send a DALI command of OFF instead of the DAPC command to 0.
SystemFailureLevel
Send System Failure Level command in broadcast.
PowerOnLevel
Send Power On Level command in broadcast.
Fade time
Send Set fade time command in broadcast
DT8 management Enable management of devices that support DT8.
SystemFailureColor Send System failure Color command for RGBW components.
PowerOnColor Send Power On Color command for RGBW components.
After changing the settings click on the top right button "APPLY" otherwise the changes will be lost.
ATTENTION: Integration with Control4 can currently only function in the 3 distinct modes (address, group or broadcast). There is no
mixed mode (e.g. both address and group). For this reason, it is recommended to carefully consider which mode to use from the
start, depending on the project.
To Next Page
Loading...