Piranha Color Camera User’s Manual 81
DALSA 03-032-10211-01 5/9/2007
Mnemonic Syntax Parameters Description
order FPN, PRNU, FPN, PRNU, …
x1 = Pixel start number
x2= Pixel end number
in a range from 1 to n. Where n =
2048 or 4096.
enable blue correction ebc i Enable blue correction, where:
0: Disable/Off
1: Enable/On
enable input LUT eil i Enable input LUT, where:
0: Off
1: On
end of line sequence els i Sets the end-of-line sequence:
0: Off
1: On
2: LVAL (video and statistics)
enable pixel coefficients epc i1 i2 Sets whether pixel coefficients are
enabled or disabled.
The first parameter sets the FPN
coefficients where i1 is:
0 = FPN coefficients disabled
1 = FPN coefficients enabled
The second parameter sets the PRNU
coefficients where i2 is:
0 = PRNU coefficients disabled
1 = PRNU coefficients enabled
get command log gcl Displays the last 50 commands and the
camera's response to them.
get camera model gcm Displays the camera model number.
get camera parameters gcp Displays all of the camera parameters.
get camera serial gcs Displays the camera serial number.
get camera version gcv Displays the camera's firmware
versions.
get values get s Displays the current value of the
parameter(s) set by the command s.
get fpn coefficient gfc x Read the FPN coefficient
x = pixel number to read in a range
from 1 to n. Where n = 2048 or 4096.
get help gh Returns all of the available “get”
commands.
get input LUT gil t a Display a single LUT value. Must
select a color with SCL first.
t = Tap number; 0 for all; range
modified by color selected
a = LUT address; 0 to 1023
get line gl x1 x2
Gets a line of video (without pixel
coefficients applied) displaying one
pixel value after another and the
minimum, maximum, and mean value
of the sampled line.
x1 = Pixel start number
x2 = Pixel end number
in a range from 1 to n. Where n =
2048 or 4096.
To Next Page
Loading...