Piranha Color Camera User’s Manual 82
DALSA 03-032-10211-01 5/9/2007
Mnemonic Syntax Parameters Description
get line average gla x1 x2
Read the average of line samples.
x1 = Pixel start number
x2 = Pixel end number
in a range from 1 to n. Where n =
2048 or 4096.
get prnu coeff gpc x Displays a PRNU coefficient.
x = pixel number to read in a range
from 1 to n. Where n = 2048 or 4096.
get signal frequency gsf i Reads the requested Camera Link
control frequency.
1 = EXSYNC frequency
2 = CC2
3 = Direction
4 = CC4
help h Display the online help.
load FPN coefficients lfc Loads the FPN coefficients from non-
volatile memory to current. This
command is modified by the ssn
command.
load factory settings lfs Loads the camera’s factory settings
LUT, FPN and PRNU coefficients.
Also used to clear a fatal error if the
user settings are corrupt at power up.
load input LUT lil Load input LUT’s from non-volatile
memory to current. Modified by the
ssn command.
load pixel coefficients lpc Load the previously saved PRNU
coefficients from non-volatile memory.
Modified by the ssn command.
load user settings lus Load the camera user settings from
non-volatile memory. Modified by the
ssn command.
reset camera rc Resets the entire camera (reboot).
Baud rate is not reset and reboots with
the value last used.
reset input LUT ril Set all values in all current LUT’s to
zero.
region of interest roi x1 x2 Sets the pixel range affected by the
ccg, gl, gla, cil, ccf, ccp,
and cpa commands. The parameters
are the pixel start and end values (x).
reset pixel coeffs rpc Resets the FPN and PRNU
coefficients to 0.
set add background sab ti Set 12 bit value to add at end of digital
chain.
t = Tap; 0 to 4 depending on color
selected; 0 for all taps
i = Value to add
set analog gain sag t f Sets the analog gain in dB.
t = tap selection, either 1 or 4
depending on the color selected, or 0
for all taps.
f= gain value specified from –10
to
To Next Page
Loading...