Compression mode setup
12. Securing the lever hoist
WARNING!
Potential risk of personal injury and/or
damage to material.
The second chain leg of the B2447.074 Compression frame
master link is intended as a secondary safety device to secure
(bridge) the B2447.072 Lever hoist in the event that its primary
suspension or its breaking system should fail.
▪ Therefore the grab link of the chain leg has to be attached to
the compression chain and NOT to the load chain of the
lever hoist, as shown in the graphic opposite.
▪ Ensure the grab link is properly attached and its safety latch is
locked.
13. Check the assembly
Before hoisting the array to its operating position, recheck the
actual status of the entire assembly according to the checklist given
in Þ Chapter 11 "Safety and system checks" on page 71.
d&b SL-Series Rigging manual 1.10 en 53
To Next Page
Loading...
Need help?
General
