Danfoss D9h - User Manual

Questions and Answers

J
Javier HowellSep 23, 2025
How to deal with torque limit issues in Danfoss DC Drives?
- J
  Jennifer GarciaSep 23, 2025
  To manage torque limit issues in Danfoss DC Drives, if the motor torque limit is exceeded during ramp up, extend the ramp up time. If the generator torque limit is exceeded during ramp down, extend the ramp down time. If torque limit occurs while running, possibly increase the torque limit, ensuring the system can operate safely at a higher torque. Also, check the application for excessive current draw on the motor.
J
Jack WheelerSep 23, 2025
How to troubleshoot live zero error on Danfoss DC Drives?
- A
  Andrew PerezSep 23, 2025
  A live zero error in Danfoss DC Drives can be caused by broken wiring or a faulty device sending the signal. Check connections on all the analog input terminals: Control card terminals 53 and 54 for signals, terminal 55 common; MCB 101 terminals 11 and 12 for signals, terminal 10 common; MCB 109 terminals 1, 3, 5 for signals, terminals 2, 4, 6 common. Also, check that the frequency converter programming and switch settings match the analog signal type. Perform Input Terminal Signal Test.
C
camerondianaSep 23, 2025
What does a brake chopper fault mean on Danfoss D9h DC Drives?
- S
  Sierra HerreraSep 23, 2025
  A brake chopper fault on Danfoss DC Drives means that if a short circuit occurs, the brake function is disabled. Remove power to the frequency converter and remove the brake resistor.
E
emilymartinSep 23, 2025
What should I do if my Danfoss D9h experience a mains failure?
- A
  Anthony SimpsonSep 23, 2025
  If your Danfoss DC Drives experience a mains failure, it indicates that the supply voltage to the frequency converter is lost. Check the fuses to the frequency converter and mains power supply to the unit.
L
Laurie TorresSep 23, 2025
What does 'DC link voltage high' mean for Danfoss D9h DC Drives?
- M
  michael53Sep 23, 2025
  The message 'DC link voltage high' for Danfoss DC Drives means that the intermediate circuit voltage (DC) is higher than the high voltage warning limit.
Z
zimmermanlaurenSep 23, 2025
What does 'DC link voltage low' mean for Danfoss D9h?
- M
  Marcus HernandezSep 23, 2025
  The message 'DC link voltage low' for Danfoss DC Drives means that the intermediate circuit voltage (DC) is lower than the low voltage warning limit.
K
Kevin LambertSep 23, 2025
What causes inrush fault in Danfoss D9h DC Drives?
- L
  lopezdeniseSep 23, 2025
  An inrush fault in Danfoss DC Drives is caused by too many power-ups occurring within a short time period. Let the unit cool to operating temperature.
K
Kevin BarreraSep 23, 2025
What causes 10 Volts low error in Danfoss D9h?
- C
  colondavidSep 23, 2025
  A '10 Volts low' error in Danfoss DC Drives can be caused by a short in a connected potentiometer or improper wiring of the potentiometer. Remove the wiring from terminal 50. If the warning clears, the problem is with the customer wiring. If the warning does not clear, replace the control card.