Danfoss ERC 211 User Guide

Installation steps
• Place the wired controller in the slot and ensure rubber sealing is resting properly on the mounting surface.
• Slide the mounting clips along the rails of the rear plastic from the rear side of the panel.
• Slide the clips towards mounting surface until controller is rmly xed.
• To remove the controller, one needs to skillfully unlatch the snapping tab and pull the clips backwards.
Dimensions
Figure 18: Dimensions (mm)
83
66
Rear mounting (lock with clips)
Drilling template
61.2
28
36
71
29
Danfoss 80G8390
Electronic refrigeration control, type ERC 21X
© Danfoss | Climate Solutions | 2023.01 BC194286421698en-000901 | 32

Danfoss ERC 211 Specifications

General

Brand	Danfoss
Model	ERC 211
Category	Controller
Language	English