Danfoss FC 100 - Page 115

Par. No. # Parameter description Default value 4 set-up Change during operation Conver-
sion index
Type
25-8* Status 25-80 Cascade Status 0 N/A All set-ups TRUE 0 VisStr[25] 25-81 Pump Status 0 N/A All set-ups TRUE 0 VisStr[25]
25-82 Lead Pump 0 N/A All set-ups TRUE 0 Uint8
25-83 Relay Status 0 N/A All set-ups TRUE 0 VisStr[4]
25-84 Pump ON Time 0 h All set-ups TRUE 74 Uint32
25-85 Relay ON Time 0 h All set-ups TRUE 74 Uint32
25-86
Reset Relay Counters [0] Do not reset All set-ups TRUE - Uint8
25-9* Service 25-90 Pump Interlock [0] Off All set-ups TRUE - Uint8 25-91 Manual Alternation 0 N/A All set-ups TRUE 0 Uint8
VLT
®
HVAC DRIVE High Power
Instruction Manual
4. How to Program
MG.11.F1.22 - VLT
®
is a registered Danfoss trademark. 115
4