FCM 300 Series
MG.03.B6.2G - VLT is a registered Danfoss trademark
Ordering form FCM 300 Series
Mounting vs. and flange size (char. nos. 24-29)
(B03) Foot 0 0 0
(B05) Flange flange size
(B35) Foot & flange flange size
(B14) Face flange size
(B34) Foot & face flange size
Tick off as appropriate and select flange size from
the table on page 4-7.
Inverter box position (char. no. 30)
(T) Top
(R) Right side
(L) Left side
Tick off as appropriate.
Inverter box position is seen from drive end.
(See drawing on page 4-7).
Drain hole position (char. nos. 31-32)
(00) None
(D1) Between feet
(D2) Opposite feet
(D3) Vertical drive end
(D4) Vertical non-drive end
(D5) 90
° °
° °
° right of feet
(D6) 90
° °
° °
° left of feet
Tick off as appropriate.
(See drawing on page 4-7).
Other options (contact Danfoss for code)
Number of FCM 300 Series ordered
Ordered by:
Ordering form FCM 300 Series
FCM type (character nos. 1-6)
Select the required FCM type from the product
range on the previous page and fill in the squares.
Application range (char. no. 7)
(P) Process
Mains voltage (char. nos. 8-9)
(T4) 3-phase 380-480 V AC
Tick off as appropriate.
Inverter vs. (char. nos. 10-11)
(ST) Standard
(SP) PROFIBUS
Tick off as appropriate.
Enclosure (char. no. 12-14)
(S55) NEMA 12 IP55
(S56) IP56
(S66) IP66
RFI filter (char. nos. 15-16)
(R1) W/ integrated filter, class A1
(R2) W/integrated filter, class B1
Tick off as appropriate.
Frame size and version
(char. nos. 17-21)
Fill in the squares with the appropriate value from
column 2 and 3 in the table on page 4-7.
Polarity (char. no. 22)
(4) 4 poles
(2) 2 poles
Tick off as appropriate.
Cooling (char. no. 23)
(1) (IC 411) Shaft mounted fan
(6) (IC 416) (not UL) Forced ventilation unit
Tick off as appropriate.
Date:
4-7
Ordering
To Next Page
Loading...
Need help?
General
