Danfoss FCM305 56

FCM 300 Series
MG.03.B6.2G - VLT is a registered Danfoss trademark
Chapter 6Chapter 6
Chapter 6Chapter 6
Chapter 6 ■
Mechanical InstallationMechanical Installation
Mechanical InstallationMechanical Installation
Mechanical Installation
Mounting Clearances............................page 6-2
Alignment ..............................................page 6-2
Maximum axial and radial loads
Standard Ball Bearings ...................page 6-2
Angular Contact Bearings...............page 6-3
Bolt Torques..........................................page 6-3
Maintenance.........................................page 6-3
■ Motor information
Motor Description..................................page 6-4
Handling the FCM 300..........................page 6-5
Bearings................................................page 6-5
Output Shafts .......................................page 6-5
■ Terminal Scpecifications........................page 6-6
Terminal and Switch Locations.............page 6-6
Connection Diagram .............................page 6-6
Tightening Torques................................page 6-7
Maximum Cable Cross Section ............page 6-7
Screw Sizes ..........................................page 6-7
■ Electrical Installation..............................page 6-8
AC line fuses .........................................page 6-8
Installation
6-1