What to do if filter bypass is activated in Danfoss Water Pump?
If the filter bypass is activated on your Danfoss Water Pump, this indicates that the filter is clogged, causing fluid to bypass it. Replace the filter and then verify that the bypass switch indicates proper operation.
Why is my Danfoss H1P 069 function erratic?
If your Danfoss Water Pump exhibits erratic behavior, the electrical connection to the pump might be faulty. To resolve this, disconnect the connection, inspect the wires, and then reconnect them securely.
What to do if Danfoss H1P 069 Water Pump has no pump function?
If your Danfoss Water Pump isn't functioning, ensure that the controller is receiving power. If it isn't, restore power to the controller.
Why is filter bypass indicator switch not working on Danfoss Water Pump?
If the filter bypass indicator switch on your Danfoss Water Pump is giving incorrect bypass readings, the switch itself may be faulty. Check or replace the filter switch. The open resistance should be approximately 510 ?, and the closed resistance should be around 122 ?.
How to fix Danfoss H1P 069 Water Pump that operates in one direction only?
If the Danfoss Water Pump control only operates the pump in one direction, it could be due to a control coil failure. Measure the resistance at the coil pins. The resistance should be 14.20 ? (24V) or 3.66 ? (12V) at 20°C [70°F]. If the resistance is incorrect, replace the coil.
General| Brand | Danfoss |
|---|---|
| Model | H1P 069 |
| Category | Water Pump |
| Language | English |
To Next Page
