SET3E
8
GB
• Move the slider to the 2nd ON
position and use and keys
to set the time you want the
programmer to next come on.
• Move the slider to the 2nd
OFF position and use and
keys to set the time you want the
programmer to next go off .
Remember to return the slider switch to the RUN position after
programming.
2.0 Temporary User Overrides
Sometimes you may need to change the way you use your system
temporarily, i.e. due to unusually cold weather, increased hot water
requirements. The SET3E has two convenient overrides which can be
selected without aff ecting the set programme.
Note: This will only work when the slider switch is in the RUN position and
will automatically cancel at the start of the next programmed event.
Advance
• Press the ADVANCE button once
to move forward to the next
programmed event.
• If the system is on it will go off .
If it is off it will come on.
• A bar on the left of the LCD
will remind you that you have
selected Advance.
• To cancel the override, press the
ADVANCE button again.
To Next Page
Loading...
Need help?
General
