Danfoss VLT 2800 User Manual

PC Software tools
PC Software - MCT 10
All drives are equipped with a serial communication
port. We provide a PC tool for communication between
PC and frequency converter, VLT Motion Control Tool
MCT 10 Set-up Software.
MCT 10 Set-up Software
MCT 10 has been designed as an easy to use inter-
active tool for setting parameters in our frequency
converters.
The MCT 10 Set-up Software will be useful for:
• Planning a communication network off-line.
MCT 10 contains a complete frequency con-
verter database
• Commissioning frequency converters on line
• Saving settings for all frequency converters
• Replacing a drive in a network
• Expanding an existing network
• Future developed drives will be supported
MCT 10 Set-up Software support Profibus DP-V1 via
a Master class 2 connection. It makes it possible to on
line read/write parameters in a frequency converter via
the Profibus network. This will eliminate the need for
an extra communication network.
The MCT 10 Set-up Software Modules
The following modules are included in the software
package:
MCT 10 Set-up Software
Setting parameters
Copy to and from frequency converters
Documentation and print out of parameter set-
tings incl. diagrams
SyncPos
Creating SyncPos programme
Ordering number:
Please order your CD containing MCT 10 Set-up Soft-
ware using code number 130B1000.
MCT 31
The MCT 31 harmonic calculation PC tool enables
easy estimation of the harmonic distortion in a given
application. Both the harmonic distortion of Danfoss
frequency converters as well as non-Danfoss frequen-
cy converters with different additional harmonic reduc-
tion measurements, such as Danfoss AHF filters and
12-18-pulse rectifiers, can be calculated.
Ordering number:
Please order your CD containing the MCT 31 PC tool
using code number 130B1031.
MG.27.E2.02 - VLT is a registered Danfoss trademark 21
Introduction to VLT 2800

Danfoss VLT 2800 Specifications

General

Brand	Danfoss
Model	VLT 2800
Category	DC Drives
Language	English