Danfoss VLT 5000 User Manual

Synchronizing controller
74 MG.10.N4.02 - VLT is a registered Danfoss trademark
User setting: __________
721 Slave marker type
Factory setting: 0
Setting range from: 0 to: 3
User setting: __________
722 Marker interval at the slave
Factory setting: 4096 quad counts
Setting range from: 0 to: 2147483647 quad counts
User setting: __________ quad counts
723 Master marker type
Factory setting: 0
Setting range from: 0 to: 3
User setting: __________
724 Marker interval at the master
Factory setting: 4096 quad counts
Setting range from: 0 to: 2147483647 quad counts
User setting: __________ quad counts
725
Test run; Program 1:
Test run speed
Factory setting: 10 %
Setting range from: 1 to: 100 %
User setting: __________ %
Synchronous operation; Program 2:
Type of operation
Factory setting: 0
Setting range from: 0 to: 7
User setting: __________
726
Test run; Program 1:
Test run acceleration
Factory setting: 10 %
Setting range from: 1 to: 200 %
User setting: __________ %
Synchronous operation; Program 2:
Hold function
Factory setting: 0
Setting range from: 0 to: 1
User setting: __________
727
Test run; Program 1:
Test run distance
Factory setting: 4096 quad counts
Setting range from: 1 to: 2147483647 quad counts

Danfoss VLT 5000 Specifications

General

Frequency	50/60 Hz
Output Voltage Range	0-100% of input voltage
Protection Features	Overvoltage, Undervoltage, Overtemperature, Short circuit
Communication Interfaces	RS-485
Ambient Temperature Range	-10°C to +40°C
Enclosure Rating	IP20, IP21, IP55
Input Voltage	200-240V AC, 380-480V AC, 525-600V AC