Danfoss VLT 5000 User Manual

Synchronizing controller
MG.10.N4.02 - VLT is a registered Danfoss trademark 77
742 Fixed offset
Factory setting: 0
Setting range from: -2147483647 to: 2147483647
737 Gear ratio no. 0 1 2 3
738 Numerator
739 Denominator
740 Slave markers
741 Master markers
742 Fixed offset
743 Step time
Factory setting: 100 ms
Setting range from: 10 to: 2147483647 ms
User setting: __________ ms
744 Step width
Factory setting: 1
Setting range from: -2147483647 to: 2147483647
User setting: __________
745 Slave speed factor
Factory setting: 400
Setting range from: 1 to: 2147483647
User setting: __________
746 Master speed factor
Factory setting: 400
Setting range from: 1 to: 2147483647
User setting: __________
747 Synchronizing error display factor
Factory setting: 400
Setting range from: to: 2147483647
User setting: __________
748 Virtual master reference value
Factory setting: 0
Setting range from: 0 to: 3
User setting: __________
749 Virtual master acceleration
Factory setting: 25600
Hz
/
s
Setting range from: 1 to: 2147483647
Hz
/
s
User setting: __________
Hz
/
s

Danfoss VLT 5000 Specifications

General

Frequency	50/60 Hz
Output Voltage Range	0-100% of input voltage
Protection Features	Overvoltage, Undervoltage, Overtemperature, Short circuit
Communication Interfaces	RS-485
Ambient Temperature Range	-10°C to +40°C
Enclosure Rating	IP20, IP21, IP55
Input Voltage	200-240V AC, 380-480V AC, 525-600V AC