Danfoss VLT 5000 User Manual

Synchronizing controller
76 MG.10.N4.02 - VLT is a registered Danfoss trademark
732 Marker synchronizing mode
Factory setting: 0
Setting range from: 0 to: 1005
User setting: __________
733 Accuracy
Factory setting: 1000 quad counts
Setting range from: - 2147483647 to: 2147483647 quad counts
User setting: __________ quad counts
734 Marker quantity FAULT
Factory setting: 5 markers
Setting range from: 1 to: 10000 markers
User setting: __________ markers
735 Marker quantity READY
Factory setting: 10 markers
Setting range from: 1 to: 10000 markers
User setting: __________ markers
736 M-S tolerance speed
Factory setting: 0 %
Setting range from: 0 to: 100 %
User setting: __________ %
737 Gear ratio no.
Factory setting: 0
Setting range from: 0 to: 3
738 Gear ratio numerator
Factory setting: 1000
Setting range from: 1 to: 2147483647
739 Gear ratio denominator
Factory setting: 1000
Setting range from: 1 to: 2147483647
740 Slave marker quantity
Factory setting: 1
Setting range from: 1 to: 2147483647
741 Master marker quantity
Factory setting: 1
Setting range from: 1 to: 2147483647

Danfoss VLT 5000 Specifications

General

Frequency	50/60 Hz
Output Voltage Range	0-100% of input voltage
Protection Features	Overvoltage, Undervoltage, Overtemperature, Short circuit
Communication Interfaces	RS-485
Ambient Temperature Range	-10°C to +40°C
Enclosure Rating	IP20, IP21, IP55
Input Voltage	200-240V AC, 380-480V AC, 525-600V AC