Danfoss VLT AutomationDrive FC 300 Instruction Manual

1 How to Read this Instruction Manual
VLT AutomationDrive
Instruction Manual
Software version: 6.0x
This Instruction Manual can be used for all VLT AutomationDrive adjustable frequency drives with software version 6.0x.
The software version number can be seen from par. 15-43
Software Version .
1.1.1 How to Read the Instruction Manual
VLT AutomationDrive is designed to provide high shaft performance on electrical motors. Please read this manual carefully for proper use. Incorrect
handling of the adjustable frequency drive may cause improper operation of the adjustable frequency drive or related equipment, shorten lifetime or
cause other problems.
This Instruction Manual will help you get started, install, program, and troubleshoot your VLT AutomationDrive.
The VLT AutomationDrive comes in twoshaft performance levels. FC 301 ranges from scalar (U/f) to VVC+ and handles asynchronous motors only. FC
302 is a high performance adjustable frequency drive for asynchronous as well as permanent motors and handles various kinds of motor control principles
such as scalar (U/f), VVC+ and flux vector motor control.
This Instruction Manual covers both FC 301 and FC 302. Where information covers both series, we refer to VLT AutomationDrive. Otherwise, we refer
specifically to either FC 301 or FC 302.
Chapter 1, How to Read this Instruction Manual, introduces the manual and informs you of the approvals, symbols and abbreviations used in this
literature.
Chapter 2, Safety Instructions and General Warnings, contains instructions on how to handle the FC 300 correctly.
Chapter 3, How to Install, guides you through mechanical and technical installation.
Chapter 4, How to Program, shows you how to operate and program the FC 300 via the LCP.
Chapter 5, General Specifications, contains technical data about FC 300.
Chapter 6, Troubleshooting, assists you in solving problems that may occur when using FC 300.
Available Literature for FC 300
- The VLT AutomationDrive Instruction Manual provides the necessary information for getting the drive up and running.
- The VLT AutomationDrive Design Guide contains all the technical information about the drive design and applications including encoder, resolver
and relay options.
- The VLT AutomationDrive Programming Guide provides information on how to program and contain all parameters of the adjustable frequency
drive.
- The VLT AutomationDrive Profibus Instruction Manual provides the information required for controlling, monitoring and programming the drive
via a Profibus serial communication bus.
- The VLT AutomationDrive DeviceNet Instruction Manual provides the information required for controlling, monitoring and programming the drive
via a DeviceNet serial communication bus.
- The VLT AutomationDrive MCT 10 Instruction Manual provides information for installation and use of the software on a PC.
- The VLT AutomationDrive IP21 / Type 1 Instruction provides information for installing the IP21 / Type 1 option.
VLT
®
AutomationDrive FC 300 Instruction
Manual
1 How to Read this Instruction Manual
MG.33.AG.22 - VLT
®
is a registered Danfoss trademark 1-1
1

Danfoss VLT AutomationDrive FC 300 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 300
Category	DC Drives
Language	English