Danfoss VLT AutomationDrive FC 301 Installation Guide

3.5 Mounting
1. Check whether the eldbus option is already
mounted in the frequency converter. If already
mounted, go to step 6. If not mounted, go to
step 2.
2. Remove the LCP or blind cover from the
frequency converter.
3. Use a screwdriver to remove the front cover and
the LCP cradle.
4. Mount the eldbus option. Mount the option
with the connector facing up for top cable entry
(see Illustration 3.3), or with the connector facing
down for bottom cable entry (see Illustration 3.4).
If an MCB option is installed, only top cable entry
is possible.
5. Remove the knock-out plate from the new LCP
cradle.
6. Mount the new LCP cradle.
130BD876.10
1
2
4
3
1 LCP
2 LCP cradle
3 Fieldbus option
4 Connector
Illustration 3.2 Exploded View
130BD862.10
Illustration 3.3 Top Cable Entry: Option Mounted with
Connector Facing Up
130BD863.10
Illustration 3.4 Bottom Cable Entry: Option Mounted with
Connector Facing Down
Installation Installation Guide
MG33J402 Danfoss A/S © 05/2015 All rights reserved. 7
3 3

Danfoss VLT AutomationDrive FC 301 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 301
Category	DC Drives
Language	English