rubber, and cardboard can be used in energy recovery. Printed circuit boards and large electrolytic capacitors (diameter >2.5 cm)
need further treatment according to IEC 62635 guidelines. To ease recycling, plastic parts are marked with an appropriate identifica-
tion code.
Contact your local Danfoss office for further information on environmental aspects and recycling instructions for professional recy-
clers. End of life treatment must follow international and local regulations.
All drives are designed and manufactured in accordance with Danfoss company guidelines on prohibited and restricted substances.
A list of these substances is available at www.danfoss.com.
This symbol on the product indicates that it may not be disposed of as household waste.Do not dispose of equipment
containing electrical components together with domestic waste.
It must be handed over to the applicable take-back scheme for the recycling of electrical and electronic equipment.
Dispose of the product through channels provided for this purpose.
Comply with all local and currently applicable laws and regulations.
AJ330233902305en-000201 / 130R059644 | Danfoss A/S © 2021.05
Mechanical Installation
Considerations
VLT® Compressor Drive CDS 803
Design Guide
To Next Page
Loading...
Need help?
General