Danfoss VLT FC 100 Series User Manual

[1] Do reset Select Do reset [1] to return the frequency converter to the
original set-up following a control word time-out. When the val-
ue is set to
Do reset [1], the frequency converter performs the
reset and then immediately reverts to the
Do not reset [0] set-
ting.
Select
Do not reset [0] to retain the set-up specified in par. 8-04,
Select setup 1-4 following a control word time-out.
This parameter is active only when
Hold set-up [0] has been
selected in par. 8-05
End-of-Time-out Function .
8-07 Diagnosis Trigger
Option: Function:
[0]
*
Disable
[1] Trigger on alarms
[2] Trigger alarms/warn. This parameter has no function for DeviceNet.
8-10 Control Word Profile
Option: Function:
[0]
*
FC profile
[5] ODVA When this parameter is set to [0] FC profile, Instances 100/150
and 101/151 are selectable in par. 10-10.
When [3] ODVA profile is selected, Instances 20/70 and 21/71
are selectable in par. 10-10.
8-50 Coasting Select
Option: Function:
Select control of the coasting function via the terminals (digital
input) and/or via the bus.
[0] Digital input
[1] Bus
[2] Logic AND
[3]
*
Logic OR
NB!
This parameter is active only when par. 8-01
Control Site is set to [0] Digital and
control word
.
8-51 Quick Stop Select
Option: Function:
[0] Digital input
[1] Bus
[2] Logic AND
[3]
*
Logic OR Select control of the Quick Stop function via the terminals (dig-
ital input) and/or via the bus.
FC 100/ 200/ 300 DeviceNet 6. Parameters
MG.33.D3.02 - VLT
®
is a registered Danfoss trademark 55
6

Danfoss VLT FC 100 Series Specifications

General

Brand	Danfoss
Model	VLT FC 100 Series
Category	DC Drives
Language	English