Danfoss vlt fcd 302 - Start Up and Functional Testing Procedures; Pre-start Safety Inspection

1
2
3
4
5
6
7
8
9
10
11
M
12
37
130BB749.10
Illustration 2.22 Installation to Achieve a Stopping Category 0 (EN 60204-1) with Safety Cat. 3 (EN 954-1) / PL “d” (ISO 13849-1).
1 Safety device Cat. 3 (circuit interrupt device, possibly
with release input)
7 Inverter module
2
Door contact 8 Motor
3 Contactor (Coast) 9 5 V DC
4 Frequency converter 10 Safe channel
5 Mains 11 Short-circuit protected cable (according to ISO 13849-2 table D.4)
6 Control board
Installation
VLT
®
Decentral Drive FCD 302 Operating Instructions
28 MG04F302 - VLT
®
is a registered Danfoss trademark
22
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com