No. Description Warning Alarm/Trip Alarm/Trip Lock Parameter Reference
250 New spare part X
14-23 Typecode Setting
251 New Type Code X X
Table 7.1 Alarm/Warning Code List
(X) Dependent on parameter
1) Can not be
Auto reset via 14-20 Reset Mode
A trip is the action performed when an alarm arises. The
trip causes the motor to coast. Reset the trip by pressing
[Reset], or perform a reset via a digital input (parameter
group 5-1* [1]). Trip is used when the original event
causing the alarm cannot damage the frequency converter
or cause dangerous conditions. A trip lock is the action
performed when an alarm occurs, which can cause
damage to the frequency converter or connected parts. A
trip lock situation can only be reset by a power cycling.
LED Indication
Warning yellow
Alarm flashing red
Trip locked yellow and red
Troubleshooting
VLT
®
Decentral Drive FCD 302 Operating Instructions
MG04F302 - VLT
®
is a registered Danfoss trademark
69
7 7
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
To Next Page
Loading...
