5.4 Remote Programming with MCT 10 Set-
up Software
Danfoss offers a software program available for
developing, storing, and transferring frequency converter
programming. The MCT 10 Set-up Software allows the user
to connect a PC to the frequency converter and perform
live programming rather than using the LCP. Also, all
frequency converter programming can be done off-line
and simply downloaded into frequency converter. Or the
entire frequency converter profile can be loaded onto the
PC for back up storage or analysis.
The USB connector or RS-485 terminal are available for
connecting to the frequency converter.
MCT 10 Set-up Software with limited functionality is
available for free download at Danfoss
website . Enter
'MCT-10 download' in the search window.
MCT 10 Setup software with full functionality is available
on CD, part no. 130B1000.
For more information refer to the MCT 10 Set-up Software
Operating Instructions, MG10RXYY.
Programming
VLT
®
Decentral Drive FCD 302 Operating Instructions
MG04F302 - VLT
®
is a registered Danfoss trademark
63
5 5
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com