DANHAG APP-control - 11 Electrical Connection; Connection to the Heater

APP-control v10.x
11 electrical connection
11.1 connection to the heater
11.1.1 heater without radio remote control
The APP-control comes with an universal connection cable. Connect the APP-
control to the power supply (red +12V, brown ground) and the yellow wire to
the control-pin of the heater.
11.1.2 heater with radio remote control
The APP-control is connected to the already existing receiver of the remote
control, using the y-cable which is included into delivery. The Y-cable also
ensures the power supply of the APP-control.
• disconnect the original cable from the receiver
• connect the y-cable to the receiver
• connect the original cable to the y-cable
• connect the APP-control to the Y-cable
16 - 32
An overview about the mounting place of the receiver can
be found at our website:
www.danhag.com