APP-control v10.x
14.6 SMS-commands
You can control the GSM remote control by APP, SMS or call.
The following table shows the supported SMS commands.
command function
INFO Query of current settings
TEMP Query the temperature
ON switches the heater on
ON:20 switches the heater on for 20 minutes
(10, 20, 30, 40, 50, 60)
OFF switches the heater off
START0630 Timer function e.g.: heater starts at 6:30 am
STOP switches the heater off and deletes the timer
GPS Query of the last known GPS-position
1
XGPS Query of the current GPS-position
1
1
GPS-receiver required
26 - 32
If you use an APP for controlling the heating, it also sends
the corresponding SMS commands in the background.
Depending on your mobile phone contract, additional
costs may occur due to the SMS sending. Switching the
heater by calling is free of charge.
To Next Page
Loading...