APP-control v10.x
14 Configuration
After the first start you have to configure the APP-control per SMS once. The
settings are stored, even in case of disconnecting the power supply.
The following functions and settings can be configured:
Password
• for the SMS configuration you will need the 5-digit password
• the password can be modified and must consist of 5 figures
(preset "12345")
• after a reset the password will be set back to “12345”
Running time
Determines how long the heater is switched on.
To configure an impulse, set the runntime to 0 minutes, 2 seconds.
21 - 32
The maximum run-time is limited internally to about 30 or
60 minutes at some heaters. Regardless of the configured
time, the heater will shut down after the maximum rub-
time.
To Next Page
Loading...