APP-control v10.x
Switch-on delay (BASIC, W-BUS)
Determines if switching output 2 is switched simultaneously with output 1.
You can configure a switch-on delay, so output 2 will be switched after output 1.
Switch-off delay (BASIC, W-BUS)
Determines if switching output 2 and 3 are switched off simultaneously with
output 1. You can configure a switch-off delay, so output 2 and 3 will be
switched off after output 1.
Output signal (Basic, W-BUS, E-BUS)
Determines the outputsignal on pin 1 (yellow wire)
Alarm delay
Determines how long the alarm signal must be present continuously before the
alarm is triggered.
22 - 32
The switch-on delay is supported from output 2 only. The
switch-off delay is supported from output 2 and 3.
The output-signal is already preconfigured for vehicle
specific APP-controls.
To Next Page
Loading...