APP-control v10.x
12 Accessories connection
The 4-pole accessories connection (connector II) is located at
the rear side of the device. You can connect an external temperature
sensor or an GPS-receiver. If you want to connect both devices, you
willl need a Y-cable which is available as accessory.
12.1 External temperature sensor
The measured values are far more accurate.
12.2 GPS-receiver
The APP-control supports an external GPS-receiver which can be connected to
the aux-socket at the back of the module. If the ignition is switched on the
position is determined about every 1 second and can be queried via SMS. If the
ignition is switched off, the GPS-receiver is activated during determining the
position only.
You will get a SMS containing the current coordinates of the car as well as a link
to “google maps” which shows the current position on the map.
18 - 32
When you connect an external temperature sensor, the
sensor must be activated via SMS. Please send a sms with
the following text to the APP-control: 12345;35=1;#
To Next Page
Loading...