APP-control v10.x
13 Start up
Prior to start-up please read the complete instruction manual.
• Disable the PIN-request of the SIM-card
• insert the SIM-card into the APP-control
• connect the APP-control to the 14-pole connector
• wait until the APP-control is logged-in (Status-LED flashing green)
• configure the APP-control
After connecting the power supply , the APP-control will perform a selftest. The
LED will be lighting red for approx. 4 seconds and then begins to flash red
(network search). As soon as the APP-control is logged in into the GSM
network, the LED will be flashing green. Now, the APP-control is ready to
operate and can be configured.
20 - 32
Please deactivate the PIN query prior to the insertion of
the SIM card. Otherwise the APP-control cannot log in into
GSM network. Therefore please insert the SIM card – if
required - in a "normal" mobile phone and use the
function "Deactivate PIN query".
To Next Page
Loading...