<volume> The volume of the loudspeakers ranging from -41 to 0. The value -41 indicates Off, whereas values from -
40 to 0 indicates attenuation in dB.
10.3.2.2 Line input 1 level
line_input_level_1 <level><CR>
Level of line input 1 signal.
<level> The level of line input 1 ranges from -41 to 0. The value -41 indicates Off, whereas values from -40 to 0
indicates attenuation in dB.
10.3.2.3 Line output level (A-D)
line_output_level <output> <level><CR>
Adjust the level of line output signal.
<output> Indicates which output is being controlled. Possible values: ‘A’, ‘B’, ‘C’, ‘D’.
<level> The level of line output ranges from -41 to 0. The value -41 indicates Off, whereas values from -40 to 0
indicates attenuation in dB.
10.3.2.4 Define audio path
audio_path <path> <on/off><CR>
This command defines audio connections in the system.
<path> Indicates which connection is being controlled. Possible values: 'mic_to_speaker', 'mic_to_floor',
'linein_1_to_speaker', 'linein_1_to_lineout_A', ‘linein_1_to_floor’.
<on/off> Indicates, whether the audio is being routed from microphones/lineinput_1 to
speakers/lineoutput_A/floor.
10.3.2.5 Audio status complete
audio_status_done<CR>
This command terminates audio status streaming.
To Previous Page
Loading...