10.2.2.11 Microphone status complete
mic_status_done<CR>
Informs, that complete system status has been sent.
10.2.2.12 Seat state
seat_state <seat number> <seat state><CR>
Seat state information.
This information is sent from the CU to an External Control, when the state of a seat changes – a seat becomes
passive or active.
<seat number> The seat number identification of a Conference unit. An integer ranging from 1 to 65535.
<seat state> The current state of the seat. This can be "active" or "passive"
10.2.2.13 Command error
command_error <error text><CR>
The CU has received an unknown command.
<error text> is a text explaining the fault case.
Examples:
command_error unknown command<CR>
command_error syntax error<CR>
10.3 Audio Control
10.3.1 Commands from External Control to CU 6105
10.3.1.1 Set loudspeaker volume
loudspeaker_volume <volume><CR>
Set the volume of loudspeakers for all Conference units.
<volume> The volume of the loudspeakers ranging from -41 to 0. The value -41 indicates Off, whereas values from -
40 to 0 indicates attenuation in dB.
The CU responds to this command by returning a ‘loudspeaker_volume’ command.
10.3.1.2 Set line input 1 level
line_input_level_1 <level><CR>
Adjust the level of line input signal.
To Next Page