Need help?Do you have a question about the Dantherm DanX 1 and is the answer not in the manual?
General| Brand | Dantherm |
|---|---|
| Model | DanX 1 |
| Category | Touch Panel |
| Language | English |
Introduction to the DanX 1/2/3 ventilation system.
Requirements for the supporting structure and installation location.
Required clearances for operation, maintenance, and servicing.
Steps and precautions for unloading the unit.
Safe procedures for lifting and transporting the unit.
Permissible storage conditions and precautions for the unit.
Introduction to the installation process for DanX units.
Description of the DanX 1/2/3 HP and XD unit components.
Steps for physically installing the DanX unit on site.
Guidelines for connecting ductwork to the unit.
Connecting and managing condensed water drainage.
Installing supply air, return air, room, and outdoor sensors.
Connecting the Low Pressure Hot Water (LPHW) coil.
Installing the frost thermostat for the LPHW coil.
Water cooled condenser and electrical heating coil installation.
Main current, component wiring, and electrical heating coil connections.
Overview of controls, HP and XD unit functions.
General information on main breaker and control system.
Details of the LCD display and operating keys.
Navigating the menu, using buttons, and understanding the display.
Access levels and password requirements for changing settings.
Viewing display options, set points, and unit status menus.
Accessing service functions and configuring time programs.
Editing and adding daily programs for unit operation.
Configuring filter checks, heating, cooling, and external signals.
Wake up function, BMS control, Modbus interface, and system data settings.
Overview of alarm types, viewing historical and current alarms.
Humidity, temperature, de-icing, and fan control for HP units.
Humidity, temperature, and fan control for XD units.
Introduction to commissioning procedures.
Commissioning checks for dampers in HP models.
Commissioning checks for dampers in XD models.
Commissioning checks for the unit fans.
Checking the frost thermostat setting during commissioning.
Initial checks for the cooling circuit of HP models.
Importance of preventive maintenance for optimal operation.
Scheduled maintenance tasks for unit components.
Maintenance procedures for the unit cabinet.
Maintenance tasks for the unit fans.
Maintenance procedures for air filters.
Maintenance tasks for the heating coil.
Maintenance for the double cross flow heat exchanger.
Maintenance procedures for the unit dampers.
Maintenance checks for the cooling circuit.
Introduction to faultfinding and alarm indicators.
Table of common problems, causes, and recommended actions.
Procedures for safe and environmentally sound disposal of the unit.
Modbus register map for DanX XD models.
Modbus register map for DanX HP models.
EU Declaration of Conformity and harmonized standards.
List and diagrams of external spare parts for DanX units.
List and diagrams of internal spare parts for DanX units.
List of spare parts for the cooling circuit.
Technical specifications for the DanX 1 model.
Technical specifications for the DanX 2 model.
Technical specifications for the DanX 3 model.
To Next Page
