Data Aire Mini dap4 - Page 32

32 • Mini dap4 User Manual
Set Point: The range is 10 to 65% RH (factory setting is 40% RH)
Note: If Lo Humidity Alarm was set for NO – the Set Point will not appear on the screen
Once a selection or selections have been made, move the cursor to the title block (Humidity Alarms) by pressing the
ENTER key
▼ Press the DOWN key to view the next screen.
The following will be displayed (values are for reference only):
Note: Alarm messages are typically factory programmed dependent on the type of equipment and the options
ordered. When making or considering changes consult with either Data Aire engineering or service. Many of
the options require additional sensors or devices.
Press the ENTER key to advance Custom Alarm Messages. The cursor will ash over the current setting Alarm # 1
(D1-2).
Available Selections for Alarm #1:
C1 HIGH PRESSURE C2 HIGH PRESSURE HUM FLT-CHK WTR PR
SEE TAG INSIDE DOOR CUSTOM MESSAGE FAN MOTOR OVERLOAD
CHK HUMIDIFIER CYL SMOKE DETECTOR DIRTY FILTER
UNIT IN STANDBY STANDBY PUMP ON UPS ON-CHK MAIN PWR
NO FLOW – CHECK PUMP REHEAT & HUM INHIBIT HUMIDIFIER INHIBITED
REHEAT INHIBITED
Press the ENTER key to advance to Alarm # 2 (D1-2). The cursor will ash over the current setting.
Available Selections for Alarm #2:
C1 LOW PRESSURE C2 HIGH PRESSURE HUM FLT-CHK WTR PR
SEE TAG INSIDE DOOR CUSTOM MESSAGE FAN MOTOR OVERLOAD
CHK HUMIDIFIER CYL SMOKE DETECTOR DIRTY FILTER
UNIT IN STANDBY STANDBY PUMP ON UPS ON-CHK MAIN PWR
NO FLOW – CHECK PUMP REHEAT & HUM INHIBIT HUMIDIFIER INHIBITED
REHEAT INHIBITED
Once a selection or selections have been made, move the cursor to the title block (Alarm Inputs) by pressing the
ENTER key
▼ Press the DOWN key to view the next screen.
Alarm Inputs
Custom Alarm Message
Alarm #1 (DI-1)
C1 High Pressure
Alarm #2 (DI-14)
C2 High Pressure
Alarm Inputs
Custom Alarm Message
Alarm #3 (DI-15)
SEE TAG INSIDE DOOR