About this Manual
viii
• Chapter 2, “Preparing to Use a DT300 Series Board,” describes
how to unpack the DT300 Series package, check the system
requirements, install the DT300 Series software, and view the
DT300 Series documentation online.
• Chapter 3, “Installing the Board and Loading the Device Driver,”
describes how to install the DT300 Series board and load the
DT300 Series device driver.
• Chapter 4, “Attaching and Configuring a Screw Terminal
Panel/Backplane,” describes how to attach and configure the
STP300, STP68, or STP68-DIN screw terminal panel, and the 5B
Series signal conditioning backplanes.
• Chapter 5, “Wiring Signals,” describes how to wire signals to a
DT300 Series board.
• Chapter 6, “Verifying the Operation of a DT300 Series Board,”
describes how to verify the operation of a DT300 Series board
with the Quick Data Acq application
• Appendix A, “Using Your Own Screw Terminal Panel,” describes
additional considerations to keep in mind when designing your
own screw terminal panel for use with a DT300 Series board.
• An index completes this manual.
Conventions Used in this Manual
The following conventions are used in this manual:
• Notes provide useful information that requires special emphasis,
cautions provide information to help you avoid losing data or
damaging your equipment, and warnings provide information to
help you avoid catastrophic damage to yourself or your
equipment.
• Items that you select or type are shown in bold.
• Courier font is used to represent source code.
To Next Page
Loading...
Need help?
General