EasyManuals Logo

Data Translation DT300 Series Getting Started Manual

Data Translation DT300 Series
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #83 background imageLoading...
Page #83 background image
Verifying the Operation of a DT300 Series Board
73
6
6
6
6
6
6
6
6
6
6. Click Get.
The value of each digital input line in port A is displayed on the screen
in both text and graphical form.
Performing a Single Value Digital Output Operation
To verify that the board can output a single digital output value,
perform the following steps:
1. Connect a digital output to digital output line 0 of port B on the
DT300 Series board. Refer to page 55 for an example of how to
connect a digital output.
2. Click the Control menu.
3. Click Digital Output.
4. Select the appropriate DT300 Series board from the Board list
box.
5. Select digital output port B by clicking Port B.
6. Click the appropriate bits to select the digital output lines to write
to. If the bit is selected, a high-level signal is output to the digital
output line; if the bit is not selected, a low-level signal is output to
the digital output line. Optionally, you can enter an output value
in the Hex text box.
7. Click Send.
The value of each digital output line of digital port B is displayed on the
screen in both text and graphical form.

Table of Contents

Other manuals for Data Translation DT300 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Data Translation DT300 Series and is the answer not in the manual?

Data Translation DT300 Series Specifications

General IconGeneral
BrandData Translation
ModelDT300 Series
CategoryPCI Card
LanguageEnglish