vii
About this Manual
This manual describes how to set up and install the following
components:
• DT300 Series software,
• DT300 Series board,
• STP300 screw terminal panel,
• STP68 or STP68-DIN screw terminal panel, and
• 5B01 or 5B08 signal conditioning backplane.
It also describes how to wire signals to the board and how to verify
the board’s operation using the Quick Data Acq application.
Intended Audience
This document is intended for engineers, scientists, technicians, or
others responsible for setting up a DT300 Series board to perform
data acquisition operations. It is assumed that you are familiar with
the requirements of your application. It is also assumed that you are
familiar with Microsoft
Windows 98
, Windows Me (Millennium
Edition), Windows NT
4.0, or Windows 2000.
How this Manual is Organized
This manual is organized as follows:
• Chapter 1, “Overview,” describes the key features of the DT300
Series hardware and the DT300 Series software, and provides an
overview of the DT300 Series getting started procedure.
To Next Page
Loading...
Need help?
General