Datakom DKG-109 User Manual

DKG-109 User Manual V-27 (23.08.2013)
- 2 -
Section
1. INSTALLATION
1.1. Introduction to the Control Panel
1.2. Mounting the Unit
1.3. Wiring the Unit
2. INPUTS AND OUTPUTS
3. DISPLAYS
3.1. Led Displays
3.2. Language Selection
3.3. Digital Display
4. ALARMS AND WARNINGS
5. MODES OF OPERATION
6. OTHER FEATURES
6.1. Remote start operation
6.2. Sender type selection
6.3. Engine heating operation
6.4. Engine Idle Speed Operation
6.5. Engine Block Heater
6.6. Fuel Pump Control
6.7. Mains Simulation (Disable Start)
6.8. Delayed Mains Simulation, Battery Charging
6.9. Dual Genset Mutual Standby Operation
6.10. Periodic Service Request Monitoring
6.11. Engine Hours Meter
6.12. Display of Software Version
6.13. SMS message sending
6.14. Remote Monitoring and Programming
6.15. External Control of the Unit
6.16. Resuming to factory set parameters
6.17. Gas engine fuel solenoid control
6.18. Load Shedding / Dummy Load
6.19. Fuel Theft / Fuelling Messages
6.20. Firmware Update
6.21. Engine Control Mode
6.22. Dual Voltage and Frequency
6.23. Single Phase Operation
7. MODBUS COMMUNICATION
8. EVENT LOGGING
9. STATISTICAL COUNTERS
10. MAINTENANCE
11. PROGRAMMING
12. TROUBLESHOOTING
13. DECLARATION OF CONFORMITY
14. TECHNICAL SPECIFICATIONS
15. CONNECTION DIAGRAM
TABLE OF CONTENTS

Datakom DKG-109 Specifications

General

Brand	Datakom
Model	DKG-109
Category	Controller
Language	English