Datakom DKG-109 User Manual

DKG-109 User Manual V-27 (23.08.2013)
- 3 -
The unit is a control and protection panel used in gensets. It shows the measured values on its
displays. The unit is designed to provide user friendliness for both the installer and the user.
Programming is usually unnecessary, as the factory settings have been carefully selected to fit most
applications. However programmable parameters allow the complete control over the generating set.
Programmed parameters are stored in a Non Volatile Memory and thus all information is retained even
in the event of complete loss of power.
The measured parameters are:
Mains voltage phase L1 to neutral
Mains voltage phase L2 to neutral
Mains voltage phase L3 to neutral
Mains voltage phase L1-L2
Mains voltage phase L2-L3
Mains voltage phase L3-L1
Gen voltage phase L1 to neutral
Gen current phase L1
Gen frequency
Engine speed (rpm)
Gen phase L1 KW
Gen phase L1 cos
Battery voltage,
Coolant temperature
Oil pressure
Fuel level
Gen frequency
Mains frequency
1.1 Introduction to the Control Panel
1. INSTALLATION

Datakom DKG-109 Specifications

General

Brand	Datakom
Model	DKG-109
Category	Controller
Language	English