Datakom DKG-119 - User Manual

To Next Page

DKG-119 User Manual V-27 (20.04.2012)

DKG-119 MANUAL AND

REMOTE START UNIT

True RMS measurements

Engine control

Generator protection

Built in alarms and warning

Dual genset mutual standby operation

Load shedding, dummy load

Gas engine support

Engine idle speed control

1 phase genset voltage inputs

1 phase genset CT inputs

Engine oil pressure measurement

Engine coolant temperature

measurement

Fuel level measurement

Genset active power measurement

Genset power factor measurement

Engine rpm display

Remote Start operation available

Mains simulation input

Engine Idle speed control

Periodic maintenance request

Engine hours counter

Event logging with complete

measurement values

Stores last 100 events

Statistical counters

3 level password protection

Programmable parameters

All parameters field adjustable

Return to factory settings enabled

Logic level serial port

Firmware downloadable from serial port

Free MS-Windows Remote monitoring

SW:

-monitoring and control

- download of parameters

GSM-SMS sending in case of alarm

Modem call in case of alarm

MODBUS communication

128x64 graphic LCD display

Triple language support

Customer logo display capability

Configurable analogue inputs: 3

Configurable digital inputs: 5

Configurable digital outputs: 2

Total digital outputs: 4

Survives cranking dropouts

Sealed front panel

Plug-in connection system for easy

replacement

Dimensions (96x96x53mm)

FEATURES

Main Page

Need help?

Do you have a question about the Datakom DKG-119 and is the answer not in the manual?

Summary

Installation

Introduction to the Control Panel

Explains the unit's purpose, user friendliness, and measured parameters.

Mounting the Unit

Details the procedure for panel mounting the unit, including dimensions and brackets.

Wiring the Unit

Covers essential wiring instructions and safety warnings for unit connection.

Inputs and Outputs

Displays

Led Displays

Describes the function and indication of the unit's 5 LEDs.

Digital Display

Details the 128x64 pixel LCD display content and navigation methods.

Alarms and Warnings

Modes of Operation

Other Features

Remote Start Operation

Explains how to assign digital inputs for remote start functionality.

SMS Message Sending

Details the activation and functionality of SMS alerts for fault conditions.

Remote Monitoring and Programming

Covers the RAINBOW software for remote monitoring and unit programming.

Firmware Update

Explains the process for updating the unit's firmware in the field.

Modbus Communication

Event Logging

Statistical Counters

Maintenance

Programming

Controller Configuration

Configuration parameters for unit settings, including language and display options.

Troubleshooting

Technical Specifications

Connection Diagram