Datalogic GRYPHON - GRYPHON M BATTERY MAINTENANCE

PEN READER CONFIGURATION
Read the restore default code, then read the pen interface
selection code.
RESTORE DEFAULT
Ì$+$*oÎ
PEN
Ì$+CP6$-BÎ
DEFAULT VALUES
USB DEFAULT SETTINGS
DATA FORMAT: code identifier disabled, no field adjustment,
code length not transmitted, character replacement disabled.
USB KEYBOARD: USA keyboard, FIFO enabled, inter-
character and inter-code delays disabled, USB keyboard
speed normal.
USB COM: no handshaking, delay disabled, rx timeout 5 sec.,
ack/nack disabled, FIFO enabled, serial trigger lock disabled.
Default Headers and Terminators for each USB mode:
- USB-KBD: no header, terminator = ENTER
- USB-KBD-ALT-MODE: no header, terminator = CR
- USB-COM: no header, terminator = CR-LF
- USB-IBM-TABLE TOP: not applicable
- USB-IBM-HAND HELD: not applicable
RS232 Standard DEFAULT SETTINGS
9600 baud, no parity, 8 data bits, 1 stop bit, no handshaking,
delay disabled, rx timeout 5 sec., ack/nack disabled, FIFO
enabled, serial trigger lock disabled.
DATA FORMAT: code identifier disabled, no field adjustment,
code length not transmitted, no header, terminator = CR-LF,
character replacement disabled.
RS232 Nixdorf DEFAULT SETTINGS
9600 baud, parity odd, 8 data bits, 1 stop bit, handshaking
hardware (RTS/CTS), delay disabled, rx timeout 9.9 sec.,
ack/nack disabled, FIFO disabled, serial trigger lock disabled.
DATA FORMAT: code identifier enabled, no field adjustment,
code length not transmitted, no header, terminator = CR,
character replacement disabled.