COMPLIANCE
FCC COMPLIANCE
Modifications or changes to this equipment without the
expressed written approval of Datalogic could void the authority
to use the equipment.
This device complies with PART 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
which may cause undesired operation.
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
LED CLASS
POWER SUPPLY
This device is intended to be connected to a UL Listed/CSA
Certified computer which supplies power directly to the reader
or else be supplied by a UL Listed/CSA Certified Power Unit
marked “Class 2” or LPS power source rated
5 V, minimum 270 mA, which supplies power directly to the
reader via the power connector of the cable.
WEEE COMPLIANCE
TO EN60825-1:(2001)
To Next Page
Loading...
