Datalogic Heron HD3130 - Double Read Timeout

Enter/Exit Programming Mode Double Read Timeout
62 Heron™ HD3130
Double Read Timeout
To prevent a double read of the same label, the Double Read Timeout sets the
minimum time allowed between reads of labels of the same symbology and
data. If the unit reads a label and sees the same label again within the Double
Read Timeout, the second read of the label will be ignored. Double Read Time-
out does not apply to scan modes that require
a trigger pull for each label that
is read.
Double Read Timeout = 0.1 Second
Double Read Timeout = 0.2 Second
Double Read Timeout = 0.3 Second
Double Read Timeout = 0.4 Second
$CSNDR0A
$CSNDR14
$CSNDR1E
$CSNDR28