EasyManuals Logo

Datalogic MAGELLAN 1400I User Manual

Datalogic MAGELLAN 1400I
184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
General Features
2-2 Magellan
®
1400i
1D Double Read Timeout — cont.
1D Label Gone Timeout
This feature sets the time after the last label segment is seen before the scanner prepares for a
new label.
START / END
PROGRAMMING BAR CODES
0.7 Second
0.8 Second
0.9 Second
1 Second
START / END
PROGRAMMING BAR CODES
Sets the label gone timeout duration using hex values from 000 to 255 in increments of ten milliseconds (10ms or 0.01 seconds). To
configure this feature, scan the “START/END” bar code above to place the unit in Programming Mode, then the “Set Label Gone Tim-
eout,” followed by three digits (zero padded) from the Alphanumeric table in
Appendix C, Alpha-Numeric Pad representing the
desired time value. Exit programming mode by scanning the “START/END” bar code again.
DEFAULT SETTING FOR THIS FEATURE: 200 milliseconds (020)
Set Label Gone Timeout

Table of Contents

Other manuals for Datalogic MAGELLAN 1400I

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datalogic MAGELLAN 1400I and is the answer not in the manual?

Datalogic MAGELLAN 1400I Specifications

General IconGeneral
BrandDatalogic
ModelMAGELLAN 1400I
CategoryBarcode Reader
LanguageEnglish

Related product manuals