Datalogic Matrix 400 - Ethernet Connection (Matrix 400 XXX-010 Models Only)

TYPICAL LAYOUTS
91
6
6.6 ETHERNET CONNECTION (MATRIX 400 XXX-010 MODELS ONLY)
For Matrix 400 XXX-010 models, the Ethernet connection is possible in two different layouts.
In both layouts, before proceeding with the connection, it is necessary to configure the reader
Ethernet parameters via VisiSet™. For further details, see the Ethernet Folder in the
VisiSet™ Help On Line.
In a Point-to-Point layout the reader is connected to a local host by using a CAB-ETH-M0x
cable with a crossover adapter.
Figure 110 - Ethernet Point-to-Point Layout
CBX
Host
Matrix 400™
CAB-MS0x
CAB-ETH-M0x
PG 6000
Crossover
A
dapte
r
1
2
 Ethernet Interface (with Crossover Adapter)
 Auxiliary Serial Interface (Local Echo) (RS232)
 External Trigger (for One Shot or Phase Mode)
3